While we do not require clogging shoes for beginner class, clogging taps help you hear your footwork and make it easier to learn. For daily practice, you may purchase a set of glue-on Buck Clogging taps, and adhere them to flat-soled tennis shoes, Zumba or dance shoes.

Glue-on taps are especially good on wooden floors because there are no nail holes to potentially scratch the floor surface. As shoes wear out, glue-on taps may be pried off with a sturdy screwdriver and applied to a new pair of shoes.

---

Supplies needed

*Buck Clogging taps can be purchased from Carl’s Clogging Supply; Steven’s Clogging Supply and/or Perry’s Place.

Tap Placement

Toe Tap – Position the Buck tap so that the toe flange rests lightly against the toe-tip of the shoe.

Heel Tap – The heel tap should cover most of the shoe heel but not extend beyond the back edge. Most dancers prefer to set the heel tap in about 1/4 inch from the back edge of the shoe for safety.

Gluing on Taps

• Position taps and draw an outline of the taps on the sole of the shoe (see Tap Placement above).
• Place round stickers or masking tape over the back of the rivets. (This keeps the glue from getting into the rivets and hindering tap action.)
• Apply glue generously on the sole of the shoe inside the tap outline you drew when positioning taps. Clear Shoe Goo is recommended, but other adhesives may be used.
• Cover the back of the tap generously with Shoe Goo or other adhesive.
• Press the glued tap surface to the respective glued area on the sole of the shoe. (You are pressing two glue-covered surfaces together.)
• Use masking tape and/or rubber bands to hold the tap in position on the bottom of the shoe until the adhesive is set. Shoe Goo requires a full 48 hours (undisturbed) to set. Other adhesives may require different times.

TIP: Whatever glue you use, be sure to allow the full curing time UNDISTURBED. Glues will not hold properly if disturbed before the full setting time has elapsed. If sufficient glue is allowed to fully set, the hold should be so strong that the tap will only come off when forced with a stout screwdriver.

Where to buy taps:

• Carl’s Clogging Supplies
• Stevens Clogging Supplies
• Perry’s Place